ConvaQuip 1026 Spezifikationen PDF herunterladen (Seite 5)

Wheelchair Assist Assembly Instructions

• Measure and mark each rear wheelchair down tube at 9 1/4”

from the floor. (see figure #1)

• Measure the distance between the wheelchair rear down

tubes. Use support tubes 601-0183 for 20” to 28” or support

tubes 601-0204 for 28” to 36”. (see figure #2)

• Align support tubes with receiver tubes in rear of Wheelchair Assist unit. DO

NOT TIGHTEN RECEIVER BOLTS. (see figure #3)

• Position Wheelchair Assist unit between wheelchair rear wheels with support

tubes facing forward. (see figure #4)

• One side at a time, place the clam

wheelchair down tube as seen in figure #4. Assemble clamp, bolts,

washers and nuts as seen in figure #5. DO NOT TIGHTEN.

• Position each clamp so that the top of the clamp is aligned with 9 1/4” ma

all clamp bolts. (see figure #7)

• Center Wheelchair Assist

Unit between wheelchair rear

wheels. Tighten receiver bolts

and lock nuts. (see figure #8)

• Check Wheelchair Assist

Unit for operation.

p into the support tube and around

rk on wheelchair down tube. Tighten

1 2 3 4 5 6 7 8 9 10

Keine Kommentare

ConvaQuip 1026 Spezifikationen Seite 5